HEWLETT PACKARD (HP) DJ430
Manual de Servicio

Removing the Left End Cover
Removal 1. Remove the top cover ' page 8 8.
2. Remove the Left Rollfeed Assembly ' page 8 9. 3. Release the three clips at the bottom of the end cover: first the side clip,

then the front and back clips. These may be stiff.

B

A

C

4. Pull the end cover up, and remove it from the Printer.

Reassembling: It's not easy to reinstall the end covers on the Printer. With some practice, you should learn the knack. As a guide, before you replace an end cover, take a look at the various clips on its inside, and identify where they fit on the Printer. Make sure that the primer plunger is installed properly when reinstalling the end cover.

8-10

HP DesignJet 430, 450C and 455CA Printers

Removal and Installation